Themis RES-XR4-3U, Installation Manual

Page: 71 / 184

2—Installation and Operation
Installation Procedures
2-9
Themis Computer
3. Before inserting a new memory module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new module verti-
cally into its slot and press firmly downward until it snaps into place.
4. If all the memory modules have been replaced in the system, replace the air
flow diverter and secure it with the six screws previously removed.
5. Replace the PCI card retainer bracket and secure it with the single screw
removed in Step 1 on page 2-6.
6. If installation of motherboard components is completed, close the RES-XR4-
3U chassis by refastening the top cover removed in Section 2.1.1, “Remove
Protective Top Cover”, on page 2-1.
Figure 2-5. Memory Module Removal
downward &
outward at
each end
Press latch
Note: Make sure the memory module has the proper orientation by align-
ing the alignment notch at the bottom edge with its counterpart ridge at
the bottom of the slot.