TGB BLADE 500, Service Manual

Page: 284 / 306

16. ELECTRICAL SYSTEM
16-2
Maintenance Data
Operational precaution
●
When remove the battery, the disconnection sequence of cable terminals shall be strictly observed.
(First disconnect the negative cable terminal, next, the positive cable terminal.)
●
The model of the spark plug and the tightening torque.
● The ignition timing.
●
Adjustment of headlight.
●
Removal and installation of AC generator.
●
The maintenance free battery requires no inspection of electrolyte level and refilling of distilled water.
●
To recharge the battery, remove the battery from rack without removing ventilation caps.
●
Unless in emergency, never rapid charge the battery.
●
The voltage must be checked with the voltmeter while charging the battery.
●
As C.D.I assembly does not require an ignition timing check. In case ignition timing is incorrect, check
C.D.I and AC generator. Verify with an ignition timing light after replacement if necessary.
Technical Specification
Charging system
Description Specification
Battery
Capacity 12V18Ah
Charging rate
1.4A / 5 ~ 10 hours (standard)
14A / 0.5 hour (fast charging)
Leak current < 1mA
Charging current 1.2 A / 1500rpm
Control voltage in charging 14.5 + 0.5 V / 1500rpm
Ignition system
Description Specification
Spark plug
Model NGK CR7E / NGK DCR8E
Gap 0.8mm
Ignition coil and
resistance
Primary winding 2.9 ±
10%Ω
Secondary winding
Without cap: 15. ± 10K
Ω
With cap:20 ± 10K
Ω