Textron RANSOMES FRONT-LINE 933, Operator Instructions Manual

Page: 44 / 84

GB-F-NL-42
Fig.15
Fig.16
GB
ENGINE OIL (Check daily) (Fig.15 / 16)
1. Change engine oil and filter every 100 hours
(See engine manual for more information.)
a) First warm up the engine. Shut off engine
when warm.
b) Loosen bolts holding access cover R on the
bottom of fuel tank and pivot to the side
c) Remove oil drain plug and drain the oil from
the sump.
b) Clean plug and replace.
e) Remove oil filter V.
f) Apply a thin film of oil to the seal of the new
oil filter and install on engine.
g) Re-fill sump with the recommended engine
oil through filler cap A
h) Start the engine and allow to run for 2
minutes and check for leaks.
i) Shut off the engine allow to stand for 2
minutes
j) Recheck oil level with dipstick B and adjust
as necessary.Always check level of oil on the
dipstick. To obtain the correct
measurement, the machine should be on
level ground.
NOTE: After the oil has been added, wait one minute
and then check level of oil again with the dipstick.