Textron LHAF001, Safety And Operation Manual

Page: 58 / 150

GB-NL-F-56
Fig.38
Fig.39
GB
REAR WHEEL TOE-IN (FIg.38)
The rear wheels should toe in 1/8" from the front to
the back of the wheel.
1. Loosen locknuts L at balljoints inside each of the
rear wheels.
2. For each wheel, rotate tie rod H until the toe-in
is correct.
3. Tighten locknuts L.
STEERING SHAFT (Fig.38)
Balljoint R should just contact pin E on both sides.
1. Loosen nut M.
2. Verify steering balance by rotating steering shaft
N in its cylinder to produce full steering right and
left.
3. Tighten nut M.
ALTERNATOR (Fig.39)
The fan belt is adjusted so that it can be deflected
5mm (0.2in) with a force of 5 kg (11 lbs) applied
midway between the crankshaft and alternator
pulley. To adjust:
1. Loosen alternator bolts P.
2. Move the alternator to tighten or loosen fan belt.
3. Tighten bolts P.