TEXIO FGX-2220, Instruction Manual

Page: 154 / 229

141
8-6-4. SOURce[1|2]:APPLy:PULSe
Set
Description Outputs a pulse waveform from the selected channel when
the command has executed. Frequency, amplitude and offset
can also be set.
Note The PW settings from the SOURce[1|2]:PULS: WIDT
command are preserved. Edge and pulse width may be
adjusted to supported levels.
Repetition rates will be approximated from the frequency. For
accurate repetition rates, the period should be adjusted using
the SOURce[1|2]:PULS:PER command
Syntax SOUR[1|2]:APPLy:PULSe [<frequency> [,<amplitude>
[,<offset>] ]]
Parameter <frequency>
500μHz~25MHz
<amplitude> 1mVpp~10Vpp
(50Ω)
<offset> -4.99V
~4.99V (50Ω)
Example SOUR1:APPL:PULS 1KHZ,MIN,MAX
Sets frequency to 1kHz and sets the amplitude to minimum
and the and offset to the maximum.
8-6-5. SOURce[1|2]:APPLy:NOISe
Set
Description Outputs Gaussian noise. Amplitude and offset can also be
set.
Note Frequency cannot be used with the noise function; however a
value (or DEFault) must be specified. The frequency is
remembered for the next function used.
Syntax
SOURce[1|2]:APPLy:NOISe [<frequency|DEFault>
[,<amplitude> [,<offset>] ]]
Parameter <frequency> Not applicable
<amplitude> 1mVpp~10Vpp (50
Ω)
<offset> -4.99V
~4.99V (50Ω)
Example SOUR1:APPL:NOIS DEF, 3.0, 1.0
Sets the amplitude to 3 volts with an offset of 1 volt.