![background image](http://html1.mh-extra.com/html/texas-instruments/tms380c26/tms380c26_user-manual_1097041074.webp)
TMS380C26
NETWORK COMMPROCESSOR
SPWS010A–APRIL 1992–REVISED MARCH 1993
POST OFFICE BOX 1443
•
HOUSTON, TEXAS
77251–1443
74
PARAMETER MEASUREMENT INFORMATION
80x8x mode bus release timing
NO.
PARAMETER
MIN
MAX
UNIT
208a
Setup of asynchronous input SBRLS low before SBCLK no longer high to guarantee recognition
15
ns
208b
Hold of asynchronous input SBRLS low after SBCLK low to guarantee recognition
15
ns
208c
Hold of SBRLS low after SOWN high
0
ns
SOWN
SBRLS
(see Note A)
SBCLK
208b
208a
T(W or 2)
T3
T4
T1
T2
208c
NOTES: A. The System Interface ignores the assertion of SBRLS if it does not own the system bus. If it does own the bus, then when it detects
the assertion of SBRLS, it will complete any internally started DMA cycle and relinquish control of the bus. If no DMA transfer has
internally started, then the System Interface will release the bus before starting another.
B. If SBERR is asserted when the System Interface controls the system bus, then the current bus transfer is completed, regardless
of the value of SRDY. If the BERETRY register is non-zero, the cycle will be retried. If the BERETRY register is zero, the System
Interface will then release control of the system bus. The System Interface ignores the assertion of SBERR if it is not performing
a DMA bus cycle on the system bus. When SBERR is properly asserted and BERETRY is zero, however, the System Interface
releases the bus upon completion of the current bus transfer and halts all further DMA on the system side. The error is synchronized
to the local bus and DMA stops on the local sides. The value of the SDMAADR, SDMADDRX, and SDMALEN registers in the System
Interface are not defined after a system bus error.
C. In cycle-steal mode, state TX is present on every system bus transfer. In burst mode, state TX is present on the first bus transfer
and whenever the increment of the DMA Address Register carries beyond the least significant 16 bits.
D. SDTACK is not sampled to verify that it is deasserted.
E. Unless otherwise specified, for all signals specified as a maximum delay from the end of an SBCLK transition to the signal valid,
the signal is also specified to hold its previous value (including high-impedance) until the start of that SBCLK transition.
Figure 36. 80x8x Mode Bus Release Timing