Chapter 2
SLAU292F – November 2009 – Revised October 2013
Getting Started
2.1
Using the eZ430-Chronos Wrist Module Stand Alone
For first time use, remove the eZ430-Chronos from box and press any button twice to wake the Chronos
module from sleep mode. After the first button press, the LCD displays the same content as shown on the
box of the kit, and after the second button press, the Chronos module starts full operation.
NOTE:
For the next steps it is important to understand the eZ430-Chronos user concept. The top
and bottom LCD lines can be controlled individually by pushing the buttons on the left side.
The buttons on the right side are used to select or activate secondary functions. Detailed
instructions are available in
.
Figure 2-2. Overview eZ430-Chronos LCD
Figure 2-1. eZ430-Chronos Wrist Module Push
Buttons
2.1.1 Setting the Time
1. Push the * button until the time is displayed in the top LCD line.
2. Hold * for three seconds until the time disappears and 12H or 24H is shown on the LCD.
3. Select 12H or 24H mode by pushing the UP or DOWN buttons.
4. Press # to continue with the time adjustment.
5. Set the hours by pushing the UP or DOWN button.
6. Press # to continue with the minute adjustment.
7. Set the minutes by pushing the UP or DOWN button.
8. Press # to continue with the second adjustment.
9. Set the seconds by pushing the UP or DOWN button.
10. Press * to confirm the settings and go back to normal operation, or press # to start over with step 2.
11
SLAU292F – November 2009 – Revised October 2013
Getting Started
Copyright © 2009–2013, Texas Instruments Incorporated