Using the eZ430-Chronos Wrist Module With a PC
2.3
Using the eZ430-Chronos Wrist Module With a PC
1. The Control Center provides a variety of demos. A detailed description can be found in
.
The following sections describe only how to use the eZ430-Chronos module to control the mouse
pointer on the PC and to use it to control PowerPoint
®
presentation software.
Figure 2-4. eZ430-Chronos Control Center
2.3.1 Transmission of Acceleration Data and Button Pushes
1. Select the SimpliciTI Acc/PPT tab.
2. Click Start Access Point to start PC. When the PC is ready, the control center status line displays
"Access point started. Now start watch in ACC, PPT or synch mode".
3. Select the ACC mode in the bottom LCD line of the eZ430-Chronos module and active the data
transmission by pressing the DOWN button. The Chronos module connects to the PC (this may take a
few seconds) and starts transmitting 3-Axis acceleration values
4. After connection, the Control Center status bar reports "Receiving data from acceleration sensor" and
the values according to the axis. The graphs display the acceleration data of the Chronos module for
each axis.
15
SLAU292F – November 2009 – Revised October 2013
Getting Started
Copyright © 2009–2013, Texas Instruments Incorporated