
Quick Start
2.5.1
Main Panel
The main menu bar of the WaveVision 5 software has several control buttons as shown in
and
, which may be used to perform most tasks with a button click.
1 - Load Plot
A new plot window is created and the Plot Load dialog is displayed. The selected plot file is loaded into
the new window.
2 - Import Data
Clicking this button creates a new time-domain plot and opens the Import Data dialog. Data may be
imported from WaveVision 4 data files as well as from ASCII data files created by other programs.
3 - Create a New Time Domain Plot
Clicking this button creates a new time-domain plot. The plot will contain no data, but is available as a
data destination.
4 - Create a New Hardware Histogram Plot
Clicking this button creates a new hardware histogram plot. Hardware histograms are available only in
conjunction with evaluation boards which can gather histogram data internally. This button is enabled
only when an evaluation board which supports hardware histograms is attached.
5 - Acquire Data
Click this button to acquire data to the active plot. If you have created more than one plot, the Active
plot has a highlighted title bar.
6 - Continuous Acquisition
This button is a toggle - when it is pressed, data is acquired continuously, one buffer after another as
fast as the hardware can go; when pressed again data acquisition stops. When in continuous
acquisition mode, acquisition may be started and stopped using the Acquire button without leaving the
continuous acquisition mode.
7 - FFT Averaging
This button is also a toggle - when it is pressed, FFT's are averaged. The number of buffers to be
averaged is specified in the hardware section of the Signal Sources tab.
Please refer to the
WaveVision 5 Users Guide
for more information.
2.5.2
Plot Window Controls
Figure 8. WaveVision 5 plot window controls
1 - Load Plot
The Plot Load dialog is displayed, and the selected plot file is loaded into the new window.
11
SNAU146 – September 2013
ADC1xDxxxx(RF)RB Reference Board
Copyright © 2013, Texas Instruments Incorporated