TESY HPWH 3.1 200 U02, Installation And Maintenance Manual

Page: 10 / 77

9
Max. starting current of heat pump A 13.5
Required overload protections A 16A T fuse/ 16A automatic switch, characteristic C (to be expected
during installation on power supply systems)
Internal thermal protection Safety thermostat with manual reset
Operating conditions
Min.÷ max temperature heat pump air intake (90%
R.H.)
°C -10 ÷ 43
Min. ÷ max temperature installation site °C 4 ÷ 40
Working temperature
Max. settable water temperature [with E-heater]
(EN 16147:2017)
°C 65 [75]
Compressor Rotary
Compressor protection Thermal circuit breaker with automatic reset
Automatic safety pressure switch (high) MPa 2.5
Automatic safety pressure switch (low) MPa 0.1
Fan Centrifugal
Available external pressure of heat pump Pa 88
Ejection outlet diameter mm 160
Nominal air capacity m3/h 360
Motor protection Internal thermal circuit breaker with automatic reset
Condenser Aluminium; wrapped externally, not in contact with water
Refrigerant R513a
Refrigerant charge g 1100
Global warming potential of the refrigerant 631
CO2 equivalent (CO2e) t 0.693
Defrosting Active with “4-way valve”
Sound emission data; EN12102:2013
Sound power Lw(A) indoor
dB(A)
57
Sound power Lw(A) outdoor 63
Automatic anti-Legionella cycle YES
Water storage tank
Descriptions
HP3.1 260S HP3.1 260 HP 3.1 200S HP3.1 200
Water storage capacity l 251 260 194 202
Solar heat exchanger surface m2 1.2 n.a. 1 n.a.
Solar heat exchanger volume l 7.5 n.a. 5.8 n.a.
Corrosion protection Mg anode Ø33x400 mm
Thermal insulation 50 mm rigid PU
Maximum working pressure – storage tank Bar 8
Transport weight Kg 140 119 121 101
*The output data refers to new appliances with clean heat exchangers!!!
The EVHP heat pump is a device intended for domestic use in conformity with the following European directives:
• 2012/19/ЕU Directive on waste electrical and electronic equipment (WEEE);
• 2011/65/EU Directive on the restrictions of use of certain hazardous substances in electric and electronic equipment
(RoHS);
• Directive 2014/30/EU - Electromagnetic compatibility (EMC);
• Directive 2014/35/EU – Low Voltage Directive (LVD);
• Directive 2009/125/EC Eco design Requirements.
The degree of protection of the equipment is equal to: IPX4.
4. IMPORTANT INFORMATION
4.1. Conformity with European regulations
4.2. Degrees of protection provided by enclosures