Parameter
No.
Description
Range
Default
Remarks
A
Lower water tank temp.
-20 ~ 99°C
Actual testing value.
B
Upper water tank temp.
-20 ~ 99°C
Actual testing value.
C
Coil temp.
-20 ~ 99°C
Actual testing value.
D
Return gas temp.
-20 ~ 99°C
Actual testing value.
E
Ambient temp.
-20 ~ 99°C
Actual testing value.
F
Electronic expansion valve opening
100~ 470
Actual testing value.
01
The setting temp. difference for heating
2 ~ 15°C
5°C
Adjustable
02
Valid days in holiday mode
3 ~ 90 days
7 days
Reserved
03
E-heater start delay
0 ~ 90min
6 min
Reserved
04
E-heater stop temperature during disinfection
50 ~ 70°C
70°C
Adjustable
05
High temp disinfection time
0 ~ 90 min
30 min
Adjustable
06
Defrost interval
30~90 min
45 min
Adjustable
07
Defrosting entry temp.
-30 ~ 0°C
-7°C
Adjustable
08
Defrosting exit temp.
2 ~ 30°C
20°C
Adjustable
09
Max defrosting cycle period
1 ~ 12 min
8 min
Adjustable
10
Electronic expansion valve adjustment
0 (auto)
0
Adjustable
11
Target overheating temp.
1 (manual)
5°C
Adjustable
12
Opening of manually adjusting the electronic expan
-
sion valve
-9 ~ 9°C
35
Adjustable
(N*10)
13
Disinfection start time
10 ~ 47
23
Adjustable
14
E-heat start temp. difference
0~23
7°C
Adjustable
15
Compressor accumulative running time
2 ~ 20°C
30 min
Adjustable
16
Lower water tank increasing temp.
10 ~ 80 min
2°C
Adjustable
17
ON/OFF
0 ~ 20°C
0 (from remote signal)
1 (from PV system)
0
Adjustable
18
Room temperature update period
2 – 120min
15 min
Adjustable
19
Compensation temperature for the climatic curve
-10 ~ 10°C
0°C
Adjustable
20
Type of temperature set control
0 (set by TS1) ~ 1 (65°C)
0
Adjustable
9.2.
Parameter list
22
Checking parameters: In any status, press this button
and hold for 3 seconds, the system parameter checking interface will be
entered.
Adjusting parameters:
• In stand by mode, press the b simultaneously for at least 3 seconds
• The symbol “00” will start flashing on the right side of the display. The PASSWORD should be entered!
• Press the button
, than only the first digit “00” will start flashing. Use the buttons
or to set
the pass word value (24)
• Press again the button
, than only the second digit of “00” will start flashing. Use the buttons
or to
set the password value
• Press again the button
, to confirm
• The first parameter will start flashing. Only the editable parameters could be changed.
• Use buttons
or to go to the parameter you want to modify and press again button to enter the
mode of changing the value.
• Change the value by pressing buttons or and press the button
, to confirm
• Quit the “Adjusting parameters mode” by pressing the button
Summary of Contents for AquaThermica Compact HPWH 3.2 100
Page 2: ......
