PORTABLE PROGRAMMER
14
With the authorisation key inserted on the Portable Programmer and the programmer
connected to the door, we press “Enter” to carry out the
Updating
.
As the cylinders, locks or wall readers have already been initialised and therefore registered
in the installation, the Portable Programmer will recognise which door it is and immediately
update it. The screen of the programmer will be:
Once the Portable Programmer finishes the operation we see the following screen:
We press
ý
(F5), to accept and go back to the main menu of the Portable Programmer.
3.5.2
Initialise
Initialising a cylinder, a lock or a wall reader consists in assigning that cylinder, lock or wall
reader to a door of the installation and transmitting it all the information concerning its locking
plan.
When a product is initialised, it loses all the information it may have stored. If it is a cylinder, lock
or wall reader in the
initial state
, it will then become part of the installation.
When a cylinder, lock or wall reader starts to form part of an installation, it can only be initialised
again with the information of another door from the same installation. That is, once initialised we
can move them from one door to another as many times as we wish, but these doors will have
to belong to the installation for which they were initialised.
We select the "
Initialise
" function of the Doors menu and press ENTER. Then we will see a
screen like the following:
LOCK
CYLINDER
