Terra TN 200D, Operation & Installation Manual

Page: 15 / 37

Revision H
August 19, 1996
11
2.7 FINAL INSPECTION
1. Insure that all wiring is properly routed and secure. Dress harnessing neatly and
secure in place with cable ties. Check connector integrity and locking devices.
Insure locking devices are functioning properly and are secured. Verify cabling is not
“clotheslined” and provisions have been made for service loops. Pull yoke to its
maximum travel. While slowly returning yoke to its normal position, rotate yoke left
and right to insure all cabling is routed and tied up properly. Cycle rudder pedals and
verify that they are free and cables are unobstructed. Install gust locks, perform
complete checkout of all avionics including dimmers. Secure aircraft power and all
master switches.
2. Have installation inspected by someone authorized under Federal Aviation Regulation
Part 65.
3. Add the Terra by Trimble TN 200D to the aircraft equipment list, including serial
number. Complete FAA Form 337 if required, and make required airframe logbook
entries. A weight and balance change may be required, depending on the type of
aircraft.
4. Complete warranty card and return to Trimble.