74 GTH-4016SR • GTH-4018SR Part No. 57.4400.9203
March 2010
Section 5 • Settings
REV A
How to Set the Machine
Functions
1. Open the dashboard and find the connector
X941 behind the fuses board.
2. Install the cable 55.0602.0203 from the
connector X941 to the computer.
3. In the computer the program “MTGTH40XX-R.
exe” has to be installed. If not, contact the
Genie Service dept.
4. Switch on the instrument panel.
5. Make the program run.
6. Select the right “COM”
7. Click on Parameters menu and then select
one of the options by clicking on it
8. Setting allows to select a parameter group:
•
Function: speed and ramp time for each
function
•
Slowing: reduction speed of some functions
depending on telehandler geometrical and
current mass value and contemporary
operations
SETTINGS
PARAMETERS - SETTING
By means of each one of parameter setting menu
is possible to:
•
Open file reading parameter data
•
Save file with parameter data (only when
parameters data have been read form display
unit or when a file has been opened)
•
Read data from disply unit (only when COM
is selected, serial adapter connected to PC
and telehandler harness and telehandler has
power switched on)
•
Write data to display unit (only when COM
is selected, serial adapter connected to PC
and telehandler harness and telehandler has
power switched on)
When a file is both opened and saved all parameters
(functions, slowing and general) are read and saved
then the file can be used to download all parameters
thruogh Parameter-Download.
But, by pressing on write data button, for example
after a modification of some parameters, ONLY
parameters related to the window (functions, slowing
or general) are written to display unit.
When a window is activated no parameters are shown
until either a read from display unit or a file opening
are done; once parameters have been read passing
to another window will show you parameters either
read or opened from a file.
