Terex Genie GS-3384, Service And Repair Manual

Page: 121 / 217

June 2021 Service and Repair Manual
Outrigger Components
Part No. 1306587GT GS ™ -84 • GS ™ -90 107
11-1
Outrigger Cylinder
How to Remove an Outrigger Cylinder (if equipped)
How to Remove an Outrigger
Cylinder (if equipped)
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Perform this procedure with the platform in
the stowed position and the outriggers fully
retracted.
1 Remove the outrigger footpad.
2 Remove the mounting fasteners from the
outrigger cover. Remove the cover.
3 Tag and disconnect the wiring from the
outrigger cylinder solenoid valve.
4 Tag, disconnect and plug the hydraulic hoses
from the outrigger cylinder. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
5 Attach a lifting strap from an overhead crane
to the barrel end of the outrigger cylinder for
support. Do not apply any lifting pressure.
6 Remove the outrigger cylinder mounting
fasteners. Remove the outrigger cylinder from
the machine.
Crushing hazard. The outrigger
cylinder may become
unbalanced and fall if not
properly supported when it is
removed from the machine.
Note: If the outrigger cylinder is being replaced,
remove the shoulder pin from the barrel end of the
outrigger cylinder and install it onto the new
cylinder.
1 valve coil
2 outrigger cylinder