Service and Repair Manual
March 2021
Scissor Components
110
GS
™
-30 • 32 • 46 • 47
Part No. 1272217GT
42 Use a soft metal drift to remove the number
5 pivot pin (index #18) from the steer end of
the machine. Remove the number 5 inner arm
(index #16) from the machine.
Crushing hazard. The number
5 inner arm (index #16) may
become unbalanced and fall if
not properly supported when
removed from the machine.
43 Tag, disconnect and plug the hydraulic hose
on the upper lift cylinder. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
44 Tag and disconnect the wire harness from the
solenoid valve on the cylinder.
45 Remove the cables from the number 4A and
4B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
46 Disconnect the number 4A and 4B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
47 Attach a lifting strap from an overhead crane
to the lug of the rod end of the upper lift
cylinder.
48 Remove the retaining fasteners from the
upper lift cylinder rod end pivot pin (index #3).
49 Use a soft metal drift to remove the upper lift
cylinder rod end pivot pin (index #3) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
50 Lower the cylinder onto the linkset.
51 Attach a lifting strap from an overhead crane
to the number 4 outer arm at the ground
control side (index #20).
52 Remove the retaining fasteners from the
number 4 center pivot pin (index #5) at the
ground control side.
53 Place a rod through the number 4 center pivot
pin at the ground control side (index #5) and
twist to remove the pin.
54 Remove the retaining fasteners from the
number 4 pivot pin (index #21) at the non-
steer end.
55 Use a soft metal drift to remove the number
4 pivot pin (index #21) from the non-steer end
of the machine. Remove the number 4 outer
arm at the ground control side (index #20)
from the machine.
Crushing hazard. The number
4 outer arm at the ground control
side (index #20) may become
unbalanced and fall if not
properly supported when
removed from the machine.
56 Attach a lifting strap from an overhead crane
to the number 4 outer arm at the battery side
(index #20).
57 Remove the retaining fasteners from the
number 4 center pivot pin (index #5) at the
battery side.
