March 2021
Service and Repair Manual
Scissor Components
Part No. 1272217GT
GS
™
-30 • 32 • 46 • 47
95
46 Remove the retaining fasteners from the
number 3 pivot pin at the steer end of the
machine (index #4).
47 Use a soft metal drift to remove the number
3 pivot pin (index #4) from the steer end of the
machine. Remove the number 3 inner arm
(index #10) from the machine.
Crushing hazard. The number
3 inner arm (index #10) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
48 Remove the cables from the number 2A and
2B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
49 Disconnect the number 2A and 2B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
50 Attach a lifting strap from an overhead crane
to the number 2 outer arm at the ground
control side (index #14).
51 Remove the retaining fasteners from the
number 2 center pivot pin (index #5) at the
ground control side.
52 Place a rod through the number 2 center pivot
pin at the ground control side (index #5) and
twist to remove the pin.
53 Remove the retaining fasteners from the
number 2 pivot pin (index #15) at the non-
steer end.
54 Use a soft metal drift to remove the number
2 pivot pin (index #15) from the non-steer end
of the machine. Remove the number 2 outer
arm at the ground control side (index #14)
from the machine.
The number 2 outer arm at the
ground control side (index #14)
may become unbalanced and
fall if not properly supported
when the pivot pin is removed.
55 Attach a lifting strap from an overhead crane
to the number 2 outer arm at the battery side
(index #14).
56 Remove the retaining fasteners from the
number 2 center pivot pin (index #5) at the
battery side.
57 Place a rod through the number 2 center pivot
pin at the battery side (index #5) and twist to
remove the pin.
Crushing hazard. The number
2 outer arm (index #14) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
58 Remove the number 2 outer arm (index #14)
from the machine.
Crushing hazard. The number
2 outer arm (index #14) may
become unbalanced and fall if
not properly supported when
removed from the machine.
59 Attach a lifting strap from an overhead crane
to the number 2 inner arm (index #13). Raise
the arm to a vertical position.
