GB
E
ng
lish
Instruction Manual
Multi Synergic 250 - Multi Synergic 380 - Multi Synergic 500 and Accessories
23. MIG-MAG WELDING:
MULTI SYNERGIC POWER SOURCE HAS THE POSSIBILITIES TO PERFORM MIG-MAG WELDING IN MANUAL OR IN SYNERGY, FOR ADVANCED
APPLICATION, THERE ARE ALSO THE POSSIBILITIES TO USE THE PROCESS PULS MIG FOR THE MOST COMMON MATERIALS.
The wire feeder unit can receive 200 or 300 mm size wire spools.
Make sure your wire spool is correctly and safely fixed to the pinion
than adjust the friction screw.
a) match the driving rolls located into the driving motor with your wire
type and size.
b) insert the wire into the driving rolls and push it till the machine euro
adaptor. Lock the driving rolls properly.
c) connect the mig torch to the machine euro adaptor.
d) press the torch trigger: wire drives for 5 sec. and stops once the
display will light “INC”.
e) release the torch trigger and press it again: wire drives now into the
torch at 10 mt/min, until trigger remain pressed.
f) Fit the shielding gas hose in to the back panel of the machine
(gas nipple marked with MIG).
Adjust the flow rate between 16/22 lt/min. depending on the welding task.
g) connect the earth clamp plug to the negative polarity.
h) adjust the welding parameter in one of the following three mode : MANUAL, SYNERGY OR PULSE MIG.
Page. 14
