GB
E
ng
lish
Instruction Manual
Multi Synergic 250 - Multi Synergic 380 - Multi Synergic 500 and Accessories
Any program of Pulse mig can be switched in double pulse at any time without the
need to change the program.
All the adjustment de-scripted for the pulse mig are the same, the selection for
doublepulsation is like a switch that allow to pass from a kind of continuously pulse
mig welding to a pulsation with a variable frequency from 0,5 to 4 time per seconds,
all the other parameters of double pulsation are set in automatic,.
NOTE: for expert welders it is possible to modify some parameters of double pulsa-
tion for special application, but the optimal regulation is the default one given from
the synergy. All the program are store into session, these session are:
ELECTRODE session
TIG session
PULSE TIG session
MANUAL MIG-MAG session
PULSE MIG session
All the data, from the main parameter and torch cycles to the “second level user
changes”, are stored inside the sessions.
The setting parameter and this session come back if selected with the first pushbut-
ton of the welding modality or when the mig torch switch is pressed, for example
after a welding in stick electrode, if the mig torch switch is pressed, the session
became the last selected with the last parameters (in this case MIG-MAG manual
with proper setting of voltage, wire speed,....) This setting is also stored as job point
and can be selected between the six jobs of the session of MIG_MAG ( refer to the
job session).
Special torches can be used in the multi Synergic.
In TIG, when the digit torch is used, it is possible to adjust the welding current
directly from the push buttons of the torch, in synergy mode, all the parameters
changes according to the synergy selection. This kind of solution helps the user that
don’t need to adjust the other parameters at the new current set.
In MIG, the use of the DIGIT MIG torch allow the direct setting from the handle of the
torch. The DIGIT MIG Torch has four push buttons in the top of the handle.
It is enough to connect the torch to the Binzel connector and than the machine rec-
ognise the external control and accept the remote adjustment.
There are two mode of working with the torch:
Analog adjustment
Jobs adjustment
NOTE: The torch adjust trough its pushbuttons also during welding, but 4 step
or 4 step + slopes cycles must be used.
Page. 18
