tenso-comfort BPM105, User Manual

Page: 19 / 33

Note:
If the cuff is too tight or too loose, this can
lead to faulty measurements.
circumference at the point of
4.2 Carrying out the blood pressure
measurement
Please note the following when carrying out
blood pressure measurements:
– Make sure there is at least a 3-minute in-
terval between two consecutive measure-
ments.
– Set comfortably and up straight. Place both
feet rmly on the oor and relax.
– When the device is held above or below
the heart, this leads to faulty measurements.
For this reason, hold your wrist with the
blood pressure meter, if possible, exactly at
heart level (see gure
– You can stop the measuring process at any
time by pressing the On/Off button.
Step 2:
Switch the device on with the On/Off button.
All display elements will appear for about
2 seconds.
Step 3:
The user identity number blinks on the dis-
play, in the measured value memory
which the result of the last blood pressure
measurement was stored (see Section 4.3
“Use by multiple persons” and Section 3.5
“Conguring the measured value memory”).
Step 4:
If the user identity number doesn’t agree
with your measured value memory, press
the MEM button until the identity number
of your measured value memory appears.
Step 5:
Conrm the measured value memory selec-
tion by pressing the On/Off button. This is
acknowledged by the measuring device with
an acoustical signal. The device now begins
by automatically pumping up the cuff.
ion:
Step 6:
After reaching the pumped up pressure, the
pump switches off and the air slowly escapes
from the cuff. The slowly falling cuff pressure
is shown on the display now. In addition, as
soon as a pulse signal is detected, a heart
symbol appears which blinks at the same rate
as the pulse.
C
ar
ry
in
g
o
ut
th
e
bl
o
o
d
pr
es
su
re
m
ea
su
re
m
en
t
4
measurement must be at least 5.31inch.
ttent A
WARNING:
26 27
WARNING
:
Operate the device only as intended.
Do not use the device for any other purpose
.
below)
.
The wrist
The pumping up of the cuff can be
terminated at any time by pressing the
On/Off button
in
If the cuff causes pain, or if you feel that the
pressure is too high, pressure can be relieved
quickly by pressing the On/Off button.
If the pressure is not relieved fast enough,
simply open the velcro closure of the cuff
in the event of an emergency.