4 Carrying out the blood pressure
measurement
Step 2:
When you press the MEM button, “CLr”
(clear) appears at the bottom of the dis-
play, which means that the memory will
be cleared.
Remark:
When the abbreviation ”CLr” appears on the
display and you switch off the device via the
On/Off button or continue by pressing the
SET button, the entire measured value mem-
ory is cleared. If you do not wish to clear the
values, press the MEM button again to make
4.1 Applying the cuff
– W
has been applied.
Step 1:
Push your sleeve up without constricting
your arm.
The cuff is closed with a velcro closure
“CLr” disappear. If you now carry out step 3,
the contents in memory will be retained.
Step 3:
If you do not wish to make any further set-
tings, exit the settings menu by pressing the
On/Off button. Otherwise, continue with
the settings by pressing the SET button.
C
ar
ry
in
g
o
ut
th
e
bl
o
o
d
pr
es
su
re
m
ea
su
re
m
en
t
4
.
and should not be too tight or too loose.
away from the heel of your hand (see gure).
The device should sit about 0.4-0.8 inch
– The cuff is suitable for a wrist circumfer-
– Pain or scars on the left arm
ence of 5.31 inch to 8.66 inch.
– Only switch the device on after the cuff
the left wrist. If the blood pressure differs
in the two arms, however, the arm with
the higher blood pressure should be used.
Further reasons for measuring on the right
arm:
ater retention in tissue (oedema,
e.g. after operation)
– IV infusion lines in the left arm or a shunt
for dialysis
Note:
– Usually, measurements should be made on
24
25
Attention: There is no possibility to clear
the memory for only one or two users
.
CAUTION:
Read all the information in this instruction
manual or any other literature before operating
the device
CAUTION: This device is intended for use in
measuring blood pressure and pulse rate in adult
population. Do not use this device on infants or
children or other persons who cannot express
their intentions.
