Step 1:
To enable (or block) the measured value
memory, press the SET button until the word
“user” appears on the display in the upper
right-hand corner, and to the left of the word
“user”, the number “1” appears (see figure).
In the lower area of the display, either the
word “on” or “off” is blinking. This is an
indication of whether the measured value
memory for user “1” is enabled or blocked at
this time.
“on” means: The measured value memory is
enabled for user “1”.
Remark:
If, for example, you (only) want to change the
measured value memory status for user “5”,
press the SET button until the number “5”
appears to the left next to the word “user”
and carry out step 2.
Step 4:
If you do not wish to make any further set-
tings, exit the settings menu by pressing the
On/Off button. Otherwise, continue with the
settings by pressing the SET button.
Note:
– If measured value memories are enabled
for several users, each user must know his
own user identity number. Before each
measurement, it must be made sure that
the correct user identity number has been
selected (see Section 4.2 “Carrying out the
blood pressure measurement”, steps 3
to 5).
– The procedure for clearing the measured
value memory is described in Section 3.7.
3.6 Resetting the wireless connection
(only applies for the BPM105 model)
Note:
The BPM105 model is equipped with a
wireless interface. With this, you can trans-
fer the measured blood pressure measure-
ments wirelessly for further processing
(e.g. statistical evaluation) or archiving to
a PC which is equipped with a Biocomfort
wireless module (USB105) or to a PDA
(equipped with wireless module CFC105).
The values are then analyzed and stored by
the Biocomfort Health Manager software.
The wireless connection should only be
reset manually when it is not possible to
reset it with the Health Manager software.
Details can be found in the software in-
structions.
“off” means: The measured value memory is
blocked for user “1”.
Step 2:
To change the measured value memory state
for user “1” from “off” to “on” or vice versa,
press the MEM button.
Step 3:
After you have set the measured value mem-
ory to the status you wish, you can set the
status of the measured value memory for user
“2” by pressing the SET button again.
G
et
tin
g s
ta
rt
ed
3
20
21
