TEMA TELECOMUNICAZIONI SRL
GSM Gateway Interface DIAL-112
MAS-DIAL112-REV06EN
Page 23 of 35
CALLINGS
•
Maximum digits to call
: maximum number of digits that make up the numbers to call through the
GSM module. Once collected, the number of digits set, DIAL-112 will send the call without
waiting further. NOTE: If you make an international call, with the number preceded by 00, it
would certainly be longer than the number of digits set. In this case, therefore, if the program
shows that the number starts with a code, it ignores the length of number and calls always after
the timeout. You can also speed up the delivery always call simply typing the numbers ending
with "#"
•
Interdigits:
maximum waiting time between two consecutive digits that make up the numbers to
call through the GSM module. If that time elapses without DIAL-112 receives new digits, it
considers the number off (even without having achieved "Maximum digits to call") and send the
call to the GSM network
•
Digits to erase from CLIP:
receiving calls from the GSM network, DIAL-112 will forward the call
to the PBX cutting from the beginning of the calling number (CLI) the quantity of digits indicated
in this parameter. Useful for example to remove the "+" symbol at the beginning of the
international prefix, not properly managed by some PBXs.
•
Dial tone:
choice of dial tone that DIAL-112 sends when the PBX commits one of his lines. It is
possible to choose from 0 (no tone), 1 (alternate urban type), 2 (continuous tone), 3 (alternate /
continuous)
•
Smart callback:
enable the function of the intelligent management of the callback. Can only
work if it is not masked the identity number for outgoing calls. We also need to configure the
parameter "PBX digits len" digits equal to the number of digits of your PBX
•
Accept anonymous calls:
allow or not to accept incoming calls on GSM modules that do not
have the identity of the caller
•
Max time outgoing calls:
allows imposing a limit on the duration of outgoing calls. Put this
parameter to 0 there are no limits to the duration of calls. If you enter a value, will be issued 3
short tones to the two parties 30 seconds before time expiry. After hearing the 3 tones, the
caller has the possibility to recharge for further 5 minutes of talk time by pressing “#” (pound) on
the ISDN phone; there are no limits on the number of times that this operation can be performed
•
ECHO cancellation:
generally this function is not needed. However, on some particular types of
PBX you might encounter a slight problem of echo. In this case enabling this feature eliminates
the problem
•
Callback SMS /Callback SMS text:
Activating this function, it is possible to do that when, on
outgoing calls, you call a phone that does not answer or is busy, the system sends a message
to that number with the text indicated. If the PBX sends the number of the caller, it is appended
to the text (the number length is determined by the parameter “PBX digits len”)
•
Programming password:
is the password that you enter when you log on via phone to remote
programming (entry into the programming is activated by typing “###“(3 pounds) followed by the
password).
