TEMA TELECOMUNICAZIONI SRL
GSM Gateway Interface DIAL-112
MAS-DIAL112-REV06EN
Page 32 of 35
10.2. Remote programming
Programming via GSM in the same way as described above, only that we need to wait for the
response to the downstream device: dial the number of GSM SIM module of DIAL-112, wait for the
answer of the downstream or the response of GSM (if DISA mode programmed), and enter the
sequence “###“ and password (1111 by default), such as local programming. The operator will be
excluded and you can proceed to programming.
10.2.1. Tables of adjustable parameters via remote/local phone
The following tables summarize the programming of the commands on the local machine or
remotely. In these tables is not accounted for all of the configuration in the system but are the only
adjustable parameters with the programming phone. Use the column "Enter Your Settings" to mark
the user settings made to the device you are programming.
Note: in the “Field Number” column, the three-digit parameter code is followed by the # (pound
key), to remind the users to always confirm the device that the data just entered is correct.
Field
Number Parameter Name
Description
Range = possibile values
Default
Field max
length (digits)
Enter Your
Settings
100 # TEI
Is the ISDN connection mode of PBX (point
to point, point-to-multipoint).
0=
point to point
1=
point-to-multipoint
Range: from 0 to 1
0
1
101 # Length of outgoing
numbers
Is the maximum length of dialed numbers to
the GSM network
Range: max 2 digits
10
2
102 # Interdigit
If the compound number is shorter than set
in parameter 101, the call is forwarded by
the end of this timeout
Range: from 0 to 99
6
2
103 # Selection tone
Tone sent to the PBX by committing the
ISDN attack
0=no tone
1=alternate tone urban type
2=continuous tone
3=alternating/continuous tone
Range: from 0 to 3
1
1
104 # CLIP cutting off
Number of digits to be cut off at the
beginning of the CLIP for incoming calls.
Range: from 0 to 9
1
1
105 # Smart callback
activation
Enable or not the smart callback function
(intelligent callback)
Range: from 0 to 1
0
1
106 # GSM module
selection
Sets how to select the modules for the GSM
outgoing calls
0=the first one
1=select by LCR
2=alternate
3=time sharing
4=follow ISDN-BCH
Range: from 0 to 4
0
1
107 #
Number of digits of
the PBX’s internal
extensions
Need to know the number of digits that the
caller should select in DISA mode, or to
recognize the number of internal extension
caller to use the smart callback function
Range: from 0 to 9
3
1
108 # DISA digits waiting
time
DISA digits waiting time on incoming calls
Range: from 0 to 99
5
2
109 # DISA activation
Enable or disable the DISA service on
incoming GSM calls
Range: from 0 to 1
0
1
110 # Radix Number
Radix telecom number for direct inward
(without “0” at the beginning of the number)
Range: max 9 digits
-
9
