SX4e GSM 1900
15
U
SER
M
ANUAL
Line
Splitter
Phone
Port
Phone
Cords
Figure 9
– An optional Line Splitter
lets you connect additional phones
to your Phonecell SX4e.
Phone Cord
To Phone Port
Figure 8: Single Port
Phone Cord
To Fax Machine
To Phone(s)
OR
1)
Locate the modular line port on your fax
machine or phone and plug in one end of
a standard phone cord.
2)
Connect the other end of the cord to the
phone port
(marked PHONE)
on the side
of your Phonecell SX4e
- see Figure 8
.
NOTE:
An RJ-11 connector will fit into the
Phone port.
NOTE:
To place outbound fax calls using the
voice jack, see the
How to Set up an Analog
Fax Bypass String
section of this manual. For
single jack programming
,
see the
How to Set
A Single Jack Option
section of this manual.
Place a Call - Adjust Your FWT
1)
Pick up the phone receiver and listen for
dial tone.
2)
If you hear dial tone, make a call.
3)
While you’re talking with the other party,
listen for buzz and echo. If you hear either,
move the antenna and/or POTS phone
until you find the location where voice
conversation is strong, and buzz and echo
are minimized.
NOTE: If you are unsuccessful in
dialing out, verify the following:
••
The antenna location needs to be
adjusted
- see Figure 2.
••
The SIM card needs to be installed and/or
set up
- see Step 4.
••
Your cellular phone number has not been
activated
- contact your cellular
service provider.
Adding More Phones
Plug in a line splitter
(not supplied)
to connect
additional phones to your FWT
- see Figure 9.
NOTE: The FWT will only let you make one
phone call at a time.
PBX/KSU Systems - NOTE: PABX
installation should only be performed by
experienced telephone technicians.
Plug In Your Telephone - continued