Installation Summary
There are five steps to installing the
Phonecell SX4e
FWT properly. These steps
are summarized below and explained in detail in the remainder of this manual.
Step 1. Choose an Antenna Location (pages 11 - 13)
••
Choose an antenna location.
••
Connect the antenna.
••
Connect the FWT to a good earth ground.
••
Connect power to the FWT. Allow time for the unit to find service
and stabilize.
••
Then, check the cellular signal strength and move the antenna
until you achieve the best signal possible.
Step 2. Plug In Your Telephone (pages 14 - 15)
••
Once the antenna is connected, hook up a phone.
••
Then, make a test call to verify proper operation.
Adjust the antenna location accordingly.
NOTE
:
If your
Phonecell SX4e
did not come
with a pre-installed mini-SIM
(Subscriber Identity
Module)
card, you need to perform the SIM Card
Installation and Setup procedure in Step 4. Then,
return to this step (2).
••
Choose Single or Dual jack option (Dual jack allows
you to connect a separate fax line)- see the
Connect Your Telephone
section of this manual.
••
You may plug in additional phones via a Line Splitter
(not supplied)
if desired.
Step 3. Optional PC Data Connection (pages 16 - 19)
••
Now that the Phonecell is functioning properly,
plug in your computer for computer digital
fax/data transmission, using a DB-9 cable
(not supplied)
.
Step 4. SIM Card Installation & Setup (pages 20 - 23)
••
If your Phonecell did not come with a pre-
installed mini-SIM card, you need to perform the
SIM Card Installation and SIM PIN Setup.
••
Otherwise, continue to Step 5.
Step 5. Wall-Mount Installation (pages 24)
••
After you’ve selected a location and made all the
necessary connections and adjustments, your
Phonecell SX4e
is ready for wall-mounting.
WARNING!
DO NOT power unit until antenna
is connected, as it may burn out
the radio transmitter.
!
SX4e GSM 1900
10
U
SER
M
ANUAL