Programming Mode - Stand Alone Default
Routing Codes
Transfer Codes
Port 1
,011
11
Port 2
,022
22
Port 3
,033
33
Port 4
,044
44
Port 5
,055
55
Port 6
,066
66
Port 7
,077
77
Port 8
,088
88
Notes:
•
M-390 will send either Factory Default or Stand Alone Default Transfer
Codes depending on which default has been selected.
•
When in the Programming Mode, three digit routing codes starting with
0 indicate the M-390 will look for call progress tones before issuing transfer
code. Three digit routing codes beginning with 1 indicate the M-390 will
look for a three tone confirmation before issuing transfer code. (Line
Sharing Switch must be programmed with command *71#1# if 1 is used.)
•
NA is printed under the Transfer Codes when it is a Factory Default Table.
These codes are proprietary and are not published.
Polling Controller Reference Manual
Page 28
