Product Registration
Please fill out the Product Registration card and return it to Teltone
Corporation. The information on the card will assist us in providing you with
Technical Support.
Technical Support
If you experience trouble with the Polling Controller, please contact Teltone
t
echnical support at 425-951-3390.
LED Indicators
A power and status indicator LED is located on the back panel and operates as
described in Table 1.
Table 1 LED Indicators on the Polling Controller
LED Operation
Indicates
Slow blink, full/half brightness
Unit idle
Slow blink, on/off
Unit in service
Steady on with double blink off every 1.5 sec
Unit sending code to LSS
Fast blink on/off
Disconnect received from LSS
Steady on, full brightness, no blink
Power present but unit not functioning properly
Connectors
All connectors are located on the back panel. Connectors consist of:
-
an RJ-11 Central Office (CO) line jack and an RJ-11 Polling Modem line jack
-
a Class 2, 24 Volt DC, 400 mA power jack. Use only with a Class 2 power source.
The center pin is positive on this coaxial power jack. The transformer operates
from a standard 120 VAC wall power. A UL and CSA approved AC to DC
transformer converts the input voltage to the 24 VDC required by the unit.
When modules are placed in a carrier, the single in-cable AC-powered supply
internal to the carrier is used so that a transformer for each unit is not required.
Power Loss
While the routing features of the Polling Controller will be disabled if a power
outage occurs, you will be able to make and receive other calls.
Polling Controller Reference Manual
Page 2
