Line Splitting - Factory Default
Routing Codes
Transfer Codes
Port 1
*01
NA
Port 2
*02
NA
Port 3
*03
NA
Port 4
*04
NA
Port 5
*05
NA
Port 6
*06
NA
Port 7
*07
NA
Port 8
*08
NA
B. (Call Progress Detect - Stand Alone Default)
If your Line Sharing Switch has been programmed to accept Stand Alone
Transfer Codes, (11,22,33, etc. for ports 1,2,3, etc.) perform the following:
Put the Polling Controller back into programming mode. Enter command
*00#*02# to go back into Stand Alone Default and then enter command *05#1#.
Reconnect the Polling Controller. Note: SLSS has the *00#*02# reset
command. With the LSS, each port transfer code must be individually
reprogrammed for stand alone operation.
Place a call to the Line Sharing
Switch by entering the dial string and appending *02 to the end of the number.
If you connect to the end device hooked up to Port 2 you have successfully
established a communication path and need not continue any further.
Line Splitting - Stand Alone Default
Routing Codes
Transfer Codes
Port 1
*01
11
Port 2
*02
22
Port 3
*03
33
Port 4
*04
44
Port 5
*05
55
Port 6
*06
66
Port 7
*07
77
Port 8
*08
88
Method 3 - Will be required if Personal Computer dialing
software does not allow a “*” or “#” in the dial strings.
Note: This method assumes dialing via a modem, where a comma in the dial
string gives a 2 second delay.
Polling Controller Reference Manual
Page 26
