B. (Stand Alone Default)
If your Line Sharing Switch has been programmed to accept Stand Alone
Transfer Codes, (11,22,33, etc. for ports 1,2,3, etc.) perform the following:
Follow the programming instructions to enter into programming mode. Enter
*00#*02# into the Polling Controller. Note: SLSS has the *00#*02# reset
command. With the LSS, each port transfer code must be individually
reprogrammed for stand alone operation.
Do the same operation to the Line
Sharing Switch. Enter *00#*02# once in the programming mode then reconnect
the equipment making sure you have a device hooked up to Port 2. Place a
call to the Line Sharing Switch by entering the dial string and appending *02 to
the end of the number. If you connect to the end device hooked up to Port 2
you have successfully established a communication path and need not
continue any further.
Stand Alone Default
Routing Codes
Transfer Codes
Port 1
*01
11
Port 2
*02
22
Port 3
*03
33
Port 4
*04
44
Port 5
*05
55
Port 6
*06
66
Port 7
*07
77
Port 8
*08
88
Method 2 - May be required for Cellular and some Telecom
Networks that do not allow dialing during call setup.
A. (Call Progress Detect - Factory Default)
If you were unable to establish a communication link with Port 2 either
because your call never reached the Line Sharing Switch or because you did
reach the switch but rang Port 1 instead, follow step 2A.
Put the Polling Controller back into the programming mode. Enter command
*00#*00# to return to Factory Default and then enter command *05#1#. Exit
programming mode and reconnect Polling Controller to host computer. Now
go back to the Line Sharing Switch and enter into programming mode. Enter
command *00#*00# to return switch to Factory Default and reconnect
equipment. Place a call to the Line Sharing Switch by entering the dial string
and appending “*02" to the end of the number. If you connect to the end
device hooked up to Port 2 you have successfully established a
communication path and need not continue any further.
Chapter 7: Quick Start Guide
40-400-00013, Rev.
C
Page 25
