Chapter 4: Programming
Commands for programming the Polling Controller are listed in Table 2.
Cancel Command
To cancel all or part of a command, enter
∗
in a command field. To cancel all
digits entered back to (but not including) the previous #, enter
∗
in a data field.
To cancel the entire command,
∗∗
in a data field aborts the entire command. If
no data is entered in a field, that field is cleared.
Transfer Codes
Remember that all transfer codes must be the same length (i.e., contain the same
number of digits) and each code must be unique. The transfer codes can use
any of the 12 DTMF digits (0-9, *, and #).
Remote Programming the LSS
The LSS can be programmed remotely from the Polling Controller, if remote
programming has been enabled at the LSS. (The factory default is remote
programming enabled.)
Note:
If you have not changed the Access Transfer Code for Remote
Programming, use Routing Digit #7 to access remote programming mode at
the LSS.
If the telephone connection is lost during programming or the LSS loses
power, the last completed command will have been saved, but any incomplete
command will be lost.
Setup Polling Controller for Programming
❑
Disconnect the host modem and connect a DTMF telephone to the Modem
jack on the Polling Controller.
❑
Go off-hook and enter # # within 15 seconds.
❑
When you hear confirmation tone (3 beeps), begin programming. If you
hear error tone (1 long beep), enter # # again.
Chapter 4: Programming
40-400-00013, Rev.
C
Page 11
