TP-8/16/24/32/64S User Manual Version No.: V1.2
- 71 -
Example: #network> connection connection1
Setting of the physical port for connection
# network/conn connection1> set phyport {parameter}
Parameter is the physical port. There are two physical ports on the device, one is FEO, the other is
FE1. So parameter’s value is fec0 or fec1.
Setting of connection static network mode
#network/conn connection1> set ip static {parameter1} {parameter2}
Parameter 1 is the IP address that will be set, and parameter 2 is netmask.
Setting of connection dhcp network mode
#network/conn connection1> set ip dhcp
There is no need of any parameter when setting connection dhcp network mode, just button enter key.
Setting of connection PPPoE network mode
#network/conn connection1> set ip pppoe {parameter1}{parameter2}
Parameter 1 is the username of pppoe; and parameter 2 is the password of it.
VLAN of connection closure
#network/conn connection1> set vlan {parameter}
Setting parameter as disable can close VLAN of connection.
VLAN of connection setting
#network/conn connection1> set vlan enable {param1} {param2}
Parameter 1 is the ID of vlan; and parameter 2 is the priority of it.
configuration of connection effect taking
# network/conn connection1> exit effect
The configuration of connection will take effect once this command is carried out.
DNS setting command
network> dns {parameter1} {parameter2}
Parameter 1 is the IP of DNS1; and parameter 2 is the IP of DNS2.
The address format is xxx.xxx.xxx.xxx. For instance, 202.116.128.86. All the IP addresses mentioned
below are subject to this format.
Gateway setting command
network> gateway {parameter}
The parameter is the gateway IP address.
NTP setting command
