TP-8/16/24/32/64S User Manual Version No.: V1.2
- 74 -
that will be set. See below:
MGC Mode:
[0] DEFAULT
[1] HW
[2] ZTE
[3] BELL
Input your choice[0~3]:
At this time only numbers chosen from 0
～
3 can be input. If the users want to give up the settings,
they are able to button “Ctrl
＋
C” or directly button enter key to get out of priority setting state.
Non-interaction setting mode
protocol_ep1>mgcmode {parameter}
Only numbers chosen from 0
～
3 can be input, which stands for the three MGC platforms under
interaction mode.
Command to set H.248 command delay
protocol_ep1> cmddelay {parameter}
The parameter is the time value of command delay, and unit is ms.
Parameter displaying command
protocol_ep1> show {parameter}
The parameter is only “all”, auth“, “ep”, heartbeat”, mg”, mgc” or “type”. If the configured parameter
value is not the same as the valued being used, CLI will display the being used value concurrently, and
before them there is “*”, for instance:
system> show mg
( "*" means the Running Config Value)
MG name: 192.168.1.1 * 192.168.1.166
MG port: 2727
Exit command
protocol_ep1> exit [parameter]
Help command
protocol_ep1> help [parameter]
6.2.4 System Parameter Settings and System Tool Command Set
You are able to enter system parameter settings and system tool contents once input “system”
command in the root command layer, see below:
＃
system
System user configuration command
