TP-8/16/24/32/64S User Manual Version No.: V1.2
- 79 -
6.2.5 CLI Cancellation Command
#logout
The command has no need of any parameter, and it is used to cancel CLI.
6.2.6 System Restart Command
# reboot
The command has no need of any parameter, and it is used to restart the target board.
6.2.7 Parameter Display Command
＃
show {parameter}
The parameter can only be “codec”, protocol”, net”, private” or “epstatus”. Of them, “codec” refers to
the compressed chip; “protocol” refers to the protocol; “net” refers to network; and “private” means
the private protocol. If the configured parameter value differs from the value being used, CLI will
display all values which are being used together, and with “*” before them. When the parameter is
“net” or “private”, CLI will also show the state of current module, for example:
＃
show private
( "*" means the Running Config Value)
Private IP: 10.25.101.1
OLT: 255
ONU: 255
Current status: CONFIGING
If the parameter is “epsatus”, the system will remind to input port number after the command is
performed. Once entered, the state of the port number, including actived state, registered MGC state,
hookswitch state, linking state and signal state, etc., will be shown, for instance:
# show epstatus
Please input endpoint index(0 for MG status) (0 ~ 24): 1
POTS1 Status
Act: ACTIVED
Port: REGISTERING
Reg: REGISTERING
Hook: HOOK_ON
Conn: IDLE
Sig: IDLE
6.2.8 Parameter Effect-taking Command
＃
take-effect
The command does not need any parameter. It is adopted to force the current all configured values to
