Telos Zephyr Xstream, User Manual

Page: 263 / 381

USER’S MANUAL
Section 12: System Functions and Remote Control 251
Name.......: etherrate
Parameter..: <8|12|14|16|18|20|24|32|40|48|56|64|80|96|112|128> Group......:
Stream Decoder
Description: Choose bitrate for Ethernet operation.
Name.......: ipdchost
Parameter..: [<host name or IP>]
Group......: Stream Decoder
Description: Set Decoder Host
Name.......: ?
Parameter..: 1: <none> 2: <command> 3: <'*'>
Group......: Misc
Description: Display list of available command & general help (1) or help for a given
command (2) or a detailed list of all commands (3)
Name.......: aes
Parameter..: -
Group......: Audio
Description: Select AES/EBU for audio input.
Name.......: aesi
Parameter..: [<compare-sf>]
Group......: Status
Description: Display info about AES/EBU receiver and transmitter chips. If 'compare -sf'
is specified this number will be used as a reference when measuring the incoming sample
frequency.
Name.......: aessrc
Parameter..: <int|32|44|48|rcv|sync>
Group......: Audio
Description: Select AES/EBU output sample rate: 'int' uses the system sample rate and no
sample rate conversion is applied, '48' converts to 48kHz, '44' to 44.1kHz, ' 32' to 32
kHz and 'rcv' to the sample rate of the AES/EBU receiver.
Name.......: ancill
Parameter..: <+|->
Group......: Misc
Description: Switch on/off ancillary data transmission and reception.
Name.......: analog
Parameter..: -
Group......: Audio
Description: Select A/D converter for audio input.
Name.......: atdt
Parameter..: -
Group......: Misc
Description: Enter transparent RS232 ancillary data mode. To return to normal console mode
enter '+++' after a guard time of 1 second.
Name.......: atdt nobreak
Parameter..: -
Group......: Misc
Description: Enter transparent RS232 ancillary data mode. Unit will persist in this mode..
Name.......: autodial
Parameter..: [<index0..99> [<name> <number1|-> <z|v> <number2|-> <z|v> [codec|custo m]]]
or <index0..99> <erase!> or <index0..99> !
If [custom], supply <enco> <deco> <bitrate> <samplerate> as per other commands
Group......: Setup
Description: Store autodial setup. The 'name' must not contain any spaces. Underscores
will
be converted to spaces. Enter a dash for the phone number if no call should be made. 'z'
specifies a Zephyr-type call, 'v' a voice call. 'codec' stores the codec settings along
with
the setup. If no parameter is specified all setups will be displayed. If 'erase!' is
specified