9
3.8 Putting into operation
Disable voicemail and notification in SMS about missed calls on the SIM card
installed into the module.
The module can handle the SIM card’s PIN code. If you wish to use the
PIN
code management, configure the SIM card’s PIN code in the programming
software at the
“Settings” section. Otherwise disable PIN code request on the
SIM card.
Enable caller identification service on the SIM card at the GSM service
provider
(this service might not be enabled by default, please check). To enable this
service, install the SIM card into a mobile phone and call the customer service of the
card’s GSM service provider and enable the service in the menu, or visit one of the
service provider’s personal customer services and ask to enable this service on the
SIM card.
Check the SIM card to be installed correctly into the module.
Check the GSM antenna to be connected correctly to the module.
Check the wires to be connected as instructed in the wiring diagram
.
You can power up the device (9-30 VAC/DC).
Make sure that the power source is
sufficient for the operation of the
Gate Control Pro
module
.
The quiescent
current of the
Gate Control Pro
module is
120mA,
however it may increase up to
500mA during communication and relay control
. If the used power source is not
sufficient for the operation of the module, this may cause malfunctions. For such cases
230VAC/12VDC-1A power adapter can be ordered separately from the manufacturer.
3.9 LED signals
Slowly flashing green
Normal operation,
connected to GSM network
Flashing red
GSM service unavailable
or system startup/restart in progress
Permanent red
SIM card error
3.10 Technical specification
Supply voltage range:
9-30 VAC/DC
Nominal current consumption:
120mA
Highest current consumption:
500mA @ 12VDC, 250mA @ 24VDC
Operating temperature:
-
20ºC - +70ºC
Transmission frequency:
GSM 900/1800 MHz
Highest load supported on outputs: 1A @ 24VAC/DC
GSM phone model:
Simcom SIM800F
Dimensions:
84 x 72 x 32mm
Weight:
200g (packed: 300g)
