WE866 HW User Guide
1VV0301330 Rev. 3
Page
45
of
54
2018-03-13
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou
autre émetteur.
WE866A1-P
Type
Dipole ½-wave antenna
RP-SMA connector
Gain
2.2 dBi
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. - Increase the separation between the
equipment and receiver. - Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. - Consult the dealer or an experienced radio/TV
technician for help.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device.
The certification label of the module shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labelled to display the FCC ID and IC of the
module, preceded by the words "Contains transmitter module", or the word "Contains", or
similar wording expressing the same meaning, as follows:
Contains FCC ID: RI7WE866A1P Contains IC: 5131A- WE866A1P
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules
qui s'y trouvent. L'étiquette de certification du module donné doit être posée sur l'appareil
hôte à un endroit bien en vue en tout temps. En l'absence d'étiquette, l'appareil hôte doit
porter une étiquette donnant le FCC ID et le IC du module, précédé des mots « Contient un
module d'émission », du mot « Contient » ou d'une formulation similaire exprimant le même
sens, comme suit :
Contains FCC ID: RI7WE866A1P Contains IC: 5131A- WE866A1P
Summary of Contents for WE866
Page 1: ...04 2016 Mod 0805 2016 08 Rev 5 WE866 HW User Guide 1VV0301330 Rev 3 2018 03 13 13...
Page 10: ...WE866 HW User Guide 1VV0301330 Rev 3 Page 10 of 54 2018 03 13 Related Documents...
Page 33: ...WE866 HW User Guide 1VV0301330 Rev 3 Page 33 of 54 2018 03 13 7 MECHANICAL DESIGN Drawing...
Page 54: ...04 2016 Mod 0805 2016 08 Rev 5...
