54
19. rip allowed
Syntax:
rip allowed
Description:
Displays the RIP versions that will be accepted and sent on each interface.
Example:
DSL>
ip rip allowed
rip send ether 2
rip send vlane 2
rip accept ether 1 2
rip accept vlane 1 2
20. rip boot
Syntax:
rip boot
Description:
Broadcasts a request for RIP information from other machines. TCP/IP does this
automatically when it first starts up, and the routing information should be kept up to date
by regular broadcasts from the other machines, so this command is normally of little use.
Example:
DSL>
ip rip boot
21. rip hostroutes
Syntax:
rip hostroutes [off]
Description:
Sets or clears the “
hostroutes
” flag; TCP/IP will accept RIP routes to individual hosts only if this
flag is on. If the flag is off, then RIP version 1 routes that appear to be to individual hosts will be
treated as if they were to the network containing the host; RIP version 2 routes to individual hosts
will be ignored. (The reason for this difference is that RIP version 1 does not allow specification of
subnet masks; a RIP version 1 route that appears to be to an individual host might in fact be to a
subnet, and treating it as a route to the whole network may be the best way to make use of the
information.) To see the state of the flag without changing it, the “
config
” command must be
used.
Configuration saving saves this information. By default the “
hostroutes
” flag is off.
Example:
DSL>
ip rip hostroutes off
22. rip killrelay
Syntax:
rip killrelay <relay>
Description:
Deletes a RIP relay. See “
rip relay
” for information on RIP relays.
23. rip poison
Syntax:
rip poison [off]
Description:
Sets or clears the “
poisoned reverse
” flag. If this flag is on, TCP/IP performs “
poisoned
reverse
” as defined in RFC 1058; see that RFC for discussion of when this is a good thing. To see
the state of the flag without changing it, the “
config
” command must be used.
Configuration saving saves this information. By default the “
poisoned reverse
” flag is off.
Example:
DSL>
ip rip poison
