11
2.
Connect to more than one computer
Excepts the items listed on step 1 above, you still need following items:
Additional PC with OS that support Ethernet interface.
Additional 10Base-T Ethernet card for each PC you want to connect
Additional 10Base-T Ethernet Straight-through cable for each PC you want
to connect.
One Ethernet Hub is required for more than one computer connection.
If your up-link hub without cascade switch, please prepare a 10Base-T
Ethernet crossover cable instead of the straight-through cable that listed on
step 1 above.
2.2 Hardware Installation
Before start to configure your Router, you have to complete all the hardware installation. The following
steps provide instructions for installing your Router.
1.
Be sure the power switch on the right side of the Router is at the
OFF
status.
2.
Connect the power adaptor to the power jack that marked
Power
at the rear panel of the
Router, then plug in the DC power adaptor to the wall electrical outlet.
3.
Connect the 10Base-T cable.
A)
If connect to computer directly
Connect one end of 10Base-T Ethernet straight-through cable to the Ethernet port on
your computer, then connect the other end of 10Base-T Ethernet straight-though cable to
the connector that marked
10Base-T
at the rear panel of the Router.
B)
If connect to more than one computer via Hub
Connect one end of 10Base-T Ethernet straight-through cable (If your up-link hub
without cascade switch, please use a 10Base-T Ethernet crossover cable instead) to the
uplink port on the Ethernet Hub, then connect the other end of 10Base-T Ethernet cable
to the connector that marked
10Base-T
at the rear panel of the Router.
4.
Connect one end of RJ11 telephone cable to the ADSL line jack that marked
ADSL
at the rear
panel of the Router, then connect the other end of RJ-11 telephone cable to the ADSL service
port that your ADSL service provider or ISP installed.
5.
Connect the male (9 pin) end of the RS-232 serial cable to the connector that marked
Console
port
at the rear panel of the Router, then plug the other end of the RS-232 serial cable to the
RS-232 serial port of your computer.
6.
Turn on the power switch. The Router should perform a self-test, and then be ready for use.
DSLAM/ISP
Ethernet Port
Serial Port
10Base-T Port
Consol Port
Up-Link
PC A
PC B
PC C
PC N
HUB
