51
6: on atm Idle, 0 rx buffers
7: on atm Idle, 0 rx buffers
8: on atm Idle, 0 rx buffers
9: on atm Idle, 0 rx buffers
10: on atm Idle, 0 rx buffers
11. ipatm lifetime
Syntax:
ipatm lifetime <secs>
Description:
Displays or sets idle time-out for IP-over-ATM SVCs: if there is no traffic on an SVC for this period,
then it will be disconnected. (It might be disconnected before this period in order to make room for
new connections.) There is no way to disable the time-out, but “
ip ipatm lifetime 999999
” will
have much the same effect.
Configuration saving saves this information. The default lifetime is 60 seconds.
Example:
DSL>
ip ipatm lifetime
Idle lifetime for connections: 1m
DSL>
ip ipatm lifetime 90
Idle lifetime for connections: 1m30s
12. ipatm pvc
Syntax:
ipatm pvc
ipatm pvc add <i/f> <vci>/[<IP address>][/<pcr>] [<port>]
ipatm pvc delete <vci> [<port>]
ipatm pvc flush
Description:
Lists configured PVCs for use by IP-over-ATM; configures another; deletes one; or deletes all.
“
<i/f>
” is the name of an interface configured for IP-over-ATM using PVCs.
“
<vci>
” is the VCI to use for the PVC. The range of possible VCIs depends on the system.
“
<IP address>
” is the IP address of the machine at the other end of the PVC. If it is not specified,
TCP/IP will use Inverse ATMARP (RFC 1577) to determine the IP address; if it is specified, then
Inverse ATMARP will not be used.
“
<pcr>
” is the peak cell rate, in cells per second. The default is 60000. (If neithe r IP address nor
PCR is specified, the “/” after the VCI can be omitted.)
“
<port>
” is the port name: it must be specified if the machine is a switch, and not otherwise.
Configuration saving saves this information.
Example:
myswitch>
ip ipatm pvc add atm 60 a3
myswitch>
ip ipatm pvc add atm 61//50000 b1
myswitch>
ip ipatm pvc add atm 62/192.168.4.32 b1
myswitch>
ip ipatm pvc
ipatm pvc atm 60//60000 A3
ipatm pvc atm 61//50000 B1
ipatm pvc atm 62/192.168.4.32/60000 B1
13. iphostname
Syntax:
iphostname add <IP address> <name>
iphostname flush
iphostname list
iphostname help [all|<cmd>]
Description:
Sets up a mapping between an IP address and a symbolic name; deletes all such mappings; lists the
mappings; or displays help on the “
iphostname
” command.
The symbolic names can be used in most IP commands where an IP address is required, and as
values of the attributes LHOST and RHOST. They are also displayed and returned as attribute
values in place of numerical addresses, when a suitable mapping exists.
The “
iphostname
” command is “
hidden
”, not shown by “
ip help
”.
Configuration saving saves this information.
