CC-10
INSTRUMENT MANUAL
Phone:(215) 947-2500 fax:(215) 947-7464 e-mail:[email protected] web site:www.televac.com
CC-10 MANUAL REV D
Page 9 of 40
Y
TELEVA
Changing modes
(1) By pushing [FUNC] key the mode moves cyclically as; 1
→ 2 → 3 → 4 → 5 → 6→7 → 8 →9→1
(2) When the mode moves to SPx(x is 1,2 or 3) set mode, SPxL set is selected first. Pushing
[ENT] key stores the value and moves to SPxH set mode. In SPxH mode by pushing [ENT] key the value is
stored then it returns to measure mode.
*If [FUNC] key is pushed instead of [ENT] button in either SPxL or SPxH mode the value is not stored and the
mode moves to the next one.
(3) In any other mode than SPx set modes, by pushing [ENT] key the value is stored and the mode returns to
the measure mode. (If [FUNC] key is pushed instead, the value is not stored and the mode moves to the next
mode.
(4) If, in any program mode, there are no operation for 30 seconds it automatically moves back to measure
mode.
(There are some exceptions)
MEASURE MODE
SP1 SET MODE
SP1L
SP1H
ENT
SP2 SET MODE
SP2L
SP2H
FUNC
SP3 SET MODE
SP3L
SP3H
ATM ADJUST MODE
XTAL ZERO ADJUST MODE
ANALOG OUTPUT SET MODE
PRESSURE UNIT SELECT MODE
COMMUNICATION SET MODE
ADDRESS
BAUD RATE
ENT
PARITY RATE
STOP BIT
ENT
ENT
CRYSTAL SENSOR PROPERTY SET MODE
O6on
ENT
XXXX*
YYYY*
ENT
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
*4 digit numbers specific to the sensor
FUNC
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
1
2
3
4
5
6
7
8
9
10
