17
6 .4 . Setup Motor
Use this menu item to configure the automatic control system for a rotating antenna
motor, where used . The receiver is preconfigured for use with a non-rotating external
installation .
Note: to edit the motor settings, you must select the setting DiSEqC 1 .2 under „Antenna
setting“ in the line „DiSEqC“ (Chapter 6 .1) .
>
Use the arrow keys up/down to mark the item „Motor Configuration“ and confirm
by pressing OK .
A window will be displayed in which basic settings for the antenna motor can be entered .
NOTE!
To avoid damage to the external installation, you may not move the external instal-
lation beyond certain limits!! (please consult the operating instructions for the
external installation for more details) .
6 .4 .1 . Limit Set
>
Use the
arrow keys up/down
to go to the line „Set Limit“
>
Use the
arrow keys left/right
to set the Western limit
>
Use the
arrow keys up/down
to go to the line Move, then direct the motor to the
Western limit using the
arrow keys left/right
>
Go back to the line „Set Limit“, and select the Eastern limit
>
Use the
arrow keys up/down
to go to the line „Move“ and use the
arrow keys
left/right
to direct the motor to the Eastern limit
6 .4 .2 . Move Steps
> 1 Press the
red
function key to call up the satellite list, or press the
green
function key
to call up the transponder list . Use the
arrow keys up/down
to select the satellite
resp . the transponder .
> 2 In the line „Move“ you can move the antenna to the position at which the satellite can
be received
> 3 Monitor the signal level and quality indicator to rotate the antenna to the optimum
position .
> 4 You can now set additional satellites as described above, beginning with Point 1 .
BDA TD 2220 HD-Lengl_07_12.indd 17
20.07.12 13:50
