11
4 .5 . Connecting an external USB storage medium
h
Connect an external USB storage device, e .g . an external hard drive, with the
USB interface of the receiver using a USB cable .
NOTE! Depending on the type of device used, the external USB storage device
may require a power supply via a separate power cable and mains
adapter . .
Please consult the operating manual supplied with the USB storage device
to be used!!
Note: USB storage devices, and in particular USB sticks, may vary significantly
with regard to their reading and writing speed . This is dependent on their quality .
Please use only branded USB sticks from reputable manufacturers, providing a
correspondingly high speed as well as sufficient storage space, in order to avoid
recording and playback errors .
Please ensure the storage device is formatted in the FAT 32 data format .
Also, the storage device must first be initialised on the receiver . This procedure may take
around 20 seconds to complete .
5 . Initial installation
If you have read the safety notes, and connected the receiver as described in Chapter 4,
you can proceed to switch the receiver on .
The factory default setting of the receiver includes pre-programming for the reception of
the satellites ASTRA 19 .2 degrees East and HOTBIRD 13 degrees East .
Where available, the receiver will start with the programme „Das ERSTE HD“, which can
be received via Astra 19 .2 degrees East .
For information on how to scan for programmes read Chapter 6 .2 .2 .
The programmes included in the programme list correspond with the programmes that
can be received via the two satellites mentioned above, and the order in which they are
entered at the factory correspond with common German viewing habits .
Switch the receiver on by means of the mains switch on the rear panel . Then start the
receiver by pressing the power key either on the front panel of the receiver or the
red
power key on the remote control .
5 .1 . Menu structure and operation
ll the settings can be made using the menu in the receiver .
>
Press the
Menu key
on the remote control to go to the main menu .
>
Use the
arrow keys up/down
/left/right to select the settings you wish to change .
>
Use the
OK
key to confirm an entry, or to go to the next item in the menu .
>
The
Exit
key will always take you one step back, or will end the menu display, or
will abort a setting procedure .
BDA TD 2220 HD-Lengl_07_12.indd 11
20.07.12 13:50
