Telemergency ClearVoice 100 B, User Manual

Page: 15 / 24

If you have already recorded a name associated with a phone #, press MENU button to go to next step or press
Exit button.
To change or record a voice name to a telephone # in the Phone Book ..
1. Press and release the Menu button until the Name Recording is shown on LCD display
2. Press and hold down OK button.. you will hear a Beep..speak into unit with the Name related to the
telephone #.
R ecord Emergency Message
(for Emergency Help System)
It is important you record the personalized message with all the important information as in B. below.
A. Your unit includes a back-up pre-recorded message “This is an emergency call, to accept this call
press zero”.
B. Your own message that must be recorded to properly use the Emergency Help System (max. recording
time is 20 seconds). The message must always end with
“please immediately hang up if you cannot
get me help now.. To accept this call press zero”.
Example: There is a medical emergency at the home of John Smith at 123 Main Street, Apt. 4D, please
come @ once. Please immediately hang up if you can't get me help now. To accept this call press zero.
To Record your own emergency message
(for Emergency Help System)
1. Press and release the MENU button until the RECORD MESSAGE is shown.
2. Press and hold the OK button. Start your message directly after the signal tone and “VOICE” icon is
flashing. While recording, keep at a distance of 10-12 inches from the telephone so that you can speak
easily into the microphone on the upper side.
3. Release the
OK button after you have finished your emergency message.
The message will now be played back automatically.
Check Emergency
Message (for Emergency Help System)
You can check the emergency message at any time.
1. Press and release the
MENU button until the CHECK MESSAGE is shown.
2. Then press the OK button to play back the message.
Setting the Tone/Pulse
(you may skip this step by pressing MENU button)
Important: Your unit is already preset to TONE dialing . If you have a tone dialing phone and tone
dialingservice, skip this step by pressing the Exit button.)
If you have a rotary (pulse) dialing system in your
home,follow these instructions.
1. Press and release the
MENU button until TONE/PULSE is shown.
2. Press the OK button, the display shows TONE .
3. Select the TONE or PULSE by scrolling or buttons.
Confirm with OK button. Unit will say TONE/PULSE.
4. Press
CLIP
(Exit) button to exit this set-up mode.
Setting the Ringer Tone
Note: Your unit is preset to a Ringer tone. (If you do not wish to change press the Exit Button)
To change..follow these steps.
1. Press and release the
MENU button until RINGER TONE is shown.
2. Press the OK button, the display shows 1 .
3. You can select ringer 1 , 2 , or 3 by scrolling or buttons.
Confirm with OK button. Unit will say LANGUAGE.
4. Press
CLIP
(Exit) button to exit this set-up mode.
Setting the language (you may skip this step by pressing MENU button)
Note: This unit has a voice menu as well as a pre-recorded emergency message that can display and/or
speak its messages in English or Spanish.
Your unit is set to English . Skip this section if you wish to
continue usage in English by pressing EXIT button.
14