22
www.telematrix.net
9600 SERIES VOIP USER GUIDE: CETIS SIP 2017
Additionally, the FNC key on the handset can be
programmed as Transfer, HOLD or MUTE .
DECT Settings
Power Level
Set the power level of the
DECT signal . Default power
level is 3 . Weakest power
level is 0 and strongest is 7 .
Frequency
Each country has a different
set of frequencies they allow
within their spectrum . The
drop-downs available set the
allowable frequency codes
for that country .
Line Sharing
Feature
The line sharing feature,
allows a second person to
share the line from another
cordless handset . This can
be disabled entirely, for no
line-sharing of handset or
set to (Enabled—Toggle
Itself) whereby the handset
(itself) can enter or leave
the call by pressing Line 1,
or set to (Enabled—Cancel
Other) to exclude the other
handset when one handset
presses Line 1, thus kicking
the other handset off the call
as a privacy mode . (Default
mode is Disabled .)
Programmable
FNC Key
The FNC key on the cordless
handset can be set in this
menu to act as transfer,
hold, or mute on that
handset .
4. Tech Notes
4.1 LLDP—Tech Notes
WHAT IS LLDP?
LLDP (Link Layer Discover Protocol) is a
standardized protocol for advertising the identity
and abilities of a device . It is useful for keeping
inventory of connected devices . It can also be
extended to advertise power requirements, VLAN
information, etc ., using LLDP-MED extensions .
Cetis phones can use LLDP information for VLAN
provisioning, enabling the phone to be placed on
the right network for configuration provisioning
without manually configuring the phone .
HOW IS IT SET-UP?
Setting LLDP up is as simple as leaving the
default settings in place on the Cetis phone .
However, the POE switch must have LLDP turned
on and be configured to use LLDP-MED for VLAN
information for the phone to receive LLDP .
To change the interval LLDP packets are sent
at, and to disable LLDP: The interval at which
LLDP sends packets can be altered from 1–3600
seconds:
1 . Log into phone’s webUI .
2 . Go to Network Settings > WAN Settings .
3 . Under LLDP Settings
a . Enable/Disable LLDP .
b . Change Packet Interval to a value from
1–3600 .
4 . Apply settings at bottom .
5 . Press reboot prompt and/or unplug phone .