9600 SERIES VOIP USER GUIDE: CETIS SIP 2017
www.telematrix.net
13
802 .1x_Password
802 .1x Authentication
password .
802 .1x_Type
Multicast (default) or
Broadcast .
3.2.7 LLDP SETTINGS
LLDP Settings
LLDP Enable
Enable or disable LLDP
feature .
Packet Interval
120 (default) .
LLDP-MED (Link Layer Discovery Protocol-
Media Endpoit Discovery) is a vendor-neutral link
layer protocol in the Internet Protocol Suite used
by network devices for advertising their identity,
capabilities, and neighbors on an IEEE 802 local
area network, principally wired Ethernet . LLDP-
MED is enabled by default on the phone and is
used to help the phone navigate to the correct
VLAN . If properly configured on the L2 switch, the
phone should arrive on the VLAN segment it is
directed to . Once on the correct VLAN, the phone
will try to obtain an IP address via DHCP .
3.2.8 LAN SETTINGS
The LAN port is used to provide network
connectivity to guest ethernet devices such as
laptops . It has several modes of operation:
• WAN/LAN Mirror—All WAN traffic is mirrored
to the LAN port . This can be used for diagnostic
troubleshooting of the phones connection by
plugging in a capture device such as a laptop
with Wireshark into the LAN port .
• Bridge—LAN traffic is passed-through the
WAN port unaltered (unless QoS settings
are specified, see appropriate section) to the
access switch .
• NAT—The WAN port address is used to
translate IP connections of devices that are
connected to the WAN .
• Disable—LAN port can not be used to connect
ethernet devices to the network .
If NAT is selected/enabled, you may use the phone
as a DHCP server as well . This is not a feature
often used in the intended hotel guestroom
setting . More often the LAN is left as bridge,
and additional QoS/VLAN settings are applied
to separate Data (LAN) and Voice (WAN) traffic .
Please see QoS settings .
3.3 VoIP Settings
You can get your SIP account information and
registration status from this page .
3.3.1 PRIMARY REGISTER
You set up your SIP account on this page . These
are the minimum required variables to enable
the phone on a SIP PBX server .
