Eye
III+
VXB
I
nstallation Guide
Page 93
Glossary
Exit Delay
The exit delay is the period of time for leaving a surveillance zone without making wrong alarm (i.e. alarm1, alarm2,
alarm3 and alarm4). The purpose is to let the user / installer have enough of time to leave the surveillance zone after the
transmitter is armed. User / installer can set the delay time for each alarm.
For example, if the time for leaving the surveillance zone is about 8 minute, it should adjust the delay time so that
Delay1 = leaving time between transmitter and Alarm1, Delay2 = leaving time between transmitter and Alarm2, Delay3
= leaving time between transmitter and Alarm3 and Delay4 = 8 minute. The alarm will be activated after the exit delay
expires.
Fire Zone
This zone will trigger alarm no matter what state the system is, ie. armed or disarmed. It is suitable for installation of
fire detectors
Arm/Disarm Input
An input to the transmitter for wiring an arm/disarm switch
Security Switch
An input to the transmitter for wiring a security switch. If the security switch is on, the system will be armed
immediately, all exit delays will be terminated. If the security switch is off, the entry delays will start.
Power Failure Input
An input to the transmitter typically used for wiring the output signal pin from a UPS
System Tamper Input
An input to the transmitter for wiring a tamper switch of the external cabinet of the transmitter and its accessories.
Armed
If the system is armed, events detected from sensors will result in an alarm.
Disarmed
If the system is disarmed, events detected from sensors will not result in an alarm.
Security Switch
Alarm 4
Alarm 3
Alarm 2
Alarm 1
Exit
Delay4
Delay3
Delay2
Delay1
Eye
III+
VXB
ARM/DisARM
Surveillance zone
Time line
