Eye
III+
I
nstallation Guide
Page 56
Appendix
Two of them are very important for setup. One of them is used for your local intranet (the field
may contain the name of your Ethernet card), the other one is used for your broadband Internet
connection. An example is shown in the following figure.
TCP/IP-> HP EN1207D-TX PCI 10/100 Fast
Ethernet Adapter
Used for Intranet (local network)
TCP/IP-> Network TeleSystems P.P.P.o.E
Adapter
Broadband Internet Access (Point-to-Point
Protocol over Ethernet)
Note that the name of these two TCP/IP adapters may be different on your computer. You have to
identify the purpose of each corresponding adapter.
Step 3:
Choose
TCP/IP->[Your Ethernet card name]
> Click
Properties
>
IP address
, enter an IP
address “
192.168.0.3
” and subnet mask “
255.255.255.0
”
Step 4:
Click
OK
and
OK
and reboot the computer.
Step 5:
After booting, ensure that the computer can still be connected to the Internet.
Step 6:
You have to confirm the IP address has been correctly set on your computer. On your windows,
click
start
>
run
, type “
winipcfg
” at Open field and pressed
OK
button, then you will see a
IP
Configuration
program shown as figure.
Summary of Contents for VT3-16BA
Page 1: ...Transmission Unit Installation Guide...
Page 7: ......
