Eye
III+
I
nstallation Guide
Page 19
System Configuration and Installation
Transmitter Configuration
After you prepared all the things discussed in previous section, you should be ready to configure the
transmitter. Note that you have to do so by following the steps discussed below before you install
and use the
Eye
III+
transmitter.
Step 1:
Connect a shielded, straight-through 9-to-9 serial cable from the serial port of the computer
to the
AUX
port of the
Eye
III+
transmitter
.
Step 2:
Turn on the
Eye
III+
transmitter
.
A blue light at the front panel will flash continuously if
it is successfully turned on.
Step 3:
Install the
Eye
III+
‘s Reception Software (WRS3-AD)
from the CD-ROM to the
computer.
Step 4:
After installation, from Start menu, select
Program Files
Eye
III+
Transmitter
Configuration
to run the Configuration
program. Then, the Configuration
program should appear as shown below:
Transmission Unit (Transmitter)
Summary of Contents for VT3-16BA
Page 1: ...Transmission Unit Installation Guide...
Page 7: ......
