Eye
III+
I
nstallation Guide
Page 39
System Configuration and Installation
Step 11
: At the
ProxyServer
page,
Enable
the Proxy Server and enter the PC IP address (e.g.
192.168.0.3 which will be configured in your computer and will be discussed later
) for
IP
field and
19001
for
port
field.
Step 12:
Ensure all settings are correct, then press the
Save and Exit
button
Step 13:
Please wait until it shows
Completed(
[baud rate]
)
message box, where
[baud rate]
shows
the serial port baud rate you are connecting between the PC and the transmitter. If
Transmission unit not found!
message is displayed, make sure that your cable
connection between the transmitter and your PC is well connected. And you can close the
configuration program and redo step 4.
Note: For advanced user, you can assign other IP addresses for PC and transmitter rather than that
provided above. But you have to remember that devices in the virtual LAN must be in same subnet.
Now you can close the configuration program, turn off the transmitter, remove the serial
cable and put it at any place you like. Then you may now need to configure your
Home
PC
(
NOT
Remote PC).
You have to set a virtual IP for your computer for your local LAN. We suggest the
following data is to be set into your computer.
IP address
192.168.0.3
Subnet mask
255.255.255.0
Default gateway
Blank
Ensure that it can successfully get on the Internet before and after configuration. For
details, please refer to appendix A to see how to set the above setting on your computer.
Summary of Contents for VT3-16BA
Page 1: ...Transmission Unit Installation Guide...
Page 7: ......
